MiBOXER (Mi-Light) 100W RGB+CCT Reflektor

MiBOXER (Mi-Light) 100W RGB+CCT Reflektor

LED strip for lighting group (zone) remote control Remote control only! A group controller is also required for operation. With the help of the group controller and remote control, you can control a maximum of 4 independent single-color (monochrome) or CCT (adjustable white color temperature) LED strips. With the help of the remote control, the following functions can be achieved: Switching off and on (main switch, for each group). , turning all groups on and off.Brightness (+/-): increasing/decreasing brightness Warmer white - Cooler white: Color temperature adjustment (from warm white to cool white) On/Off: turning groups (zones) off and on independently, or with the switch on button, you can pair the controller with the corresponding zone. Attention! It must be programmed before the first use, otherwise it will not work! When purchasing a group controller and remote control, the devices are not programmed by default, as we do not know how many devices you want to use and in which groups. Thus, before the first use, the devices must be taught to each other, the procedure for this is: Programming The controllers are in learning mode at the moment of power-up, so at this moment, within 3 seconds, the power button of the corresponding zone on the remote control must be pressed 3 times quickly. The connected LED will flash three times if teaching is successful. If it doesn't work, turn off the power to the controller and try again. Deprogramming Sometimes it may be necessary to cancel the groups. First, make sure to which group the controller is programmed, then turn off the power to the controller. Re-energize the controller, then immediately press the power button of the corresponding zone five times in a row. In case of success, the connected LED will blink ten times. In case of failure, try again.

Technical Parameters